Publicité
b. Remove the battery packs from the machine.
c. Lift the side discharge chute and secure it in the vertical position with bungee cord(s) or a rope.
d. Unfold the ramps and visually align the bottom of each ramp with the center of the corresponding rear wheel.
e. Use the measuring tape to make sure that the top ends of the ramps are parallel to the bottom ends.
f. Connect one end of the ratchet strap to the safety chain hook on the truck/trailer. connect the other end to the hinge
(or middle) of the ramp. Repeat this step with the other ramp.
g. Tighten the straps and make sure the ramps are secure and there's no movement when you tug on the ramps or
straps.
WARNING: Always make sure the ramps are properly secured. Improperly secured ramps may cause the machine
to fall down, causing serious personal injury and damage.
h. Use the measuring tape to once again verify that the ramps are parallel.
i. Make sure the machine 's parking brake pedal is disengaged.
j. Each person should place one hand on the front frame and the other hand on the plastic housing and push the
machine up the ramp. NEVER use the steering wheel and its base, the deck-height adjustment lever, or any part of
the seat to push the machine.
k. Once the machine is in the bed of the truck/trailer, secure it in place using the tie-down straps. One strap to secure
the front of the machine and two remaining strap to secure the hitch.
l. Manually turn the front wheels so they are perpendicular to the direction of the machine.
m. Engage the parking brake.
To unload the machine from a truck or trailer
a. Release the tie-down straps and disengage the parking brake.
b. Manually turn the front wheels so they are parallel to the direction of the machine.
c. Unfold the ramps and align the top of each ramp with the center of the corresponding front wheel.
d. Use the measuring tape to make sure that the bottom ends of the ramps are parallel to the top ends.
e. Connect one end of the ratchet strap to the safety chain hook on the truck/trailer. Connect the other end to the hinge
(or middle) of the ramp. Repeat this step with the other ramp.
f. Tighten the straps and make sure the ramps are secure and there's no movement when you tug on the straps.
WARNING: Always make sure the ramps are properly secured. Improperly secured ramps may cause the machine
to fall down, causing serious personal injury and damage.
g. Use the measuring tape to once again verify that the ramps are parallel.
h. Each person should place one hand on the front frame and the other hand on the plastic housing and carefully lead
the machine down the ramp. NEVER use the steering wheel and its base, the deck-height adjustment lever, or any
part of the seat to push/support the machine.
56-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT4200S/ZT4200S-FC
63
Publicité
