Télécharger Imprimer la page

Ego Power+ ZT4200S Mode D'emploi page 62

Masquer les pouces Voir aussi pour ZT4200S:

Publicité

RESETTING THE MOWER TO INITIAL FACTORY SETTING
NOTE: When the resetting is successful, below settings will return
to the initial factory setting:
driving mode
driving speed
calibration of the steering wheel
1. Insert the battery packs into the battery compartments of the
power unit.
2. Set the parking-brake pedal in the braking position.
3. Press the start/stop button briefly and the LCD screen will
show the "fuel gauge" (see Fig. 32).
4. Press and hold the LED light button and CCS button
simultaneously for more than 5 seconds, the audio indicator
will sound once and the mower status indicator over the LCD screen will flash ORANGE. Resetting is successful.
TRANSPORTING THE MACHINE (FIG. 33)
NOTICE: When using a forklift, the machine must be transported on
the bottom frame at all times! Forklift should never come in direct
contact with the machine!
We recommend to keep the bottom shipping frame to facilitate the
transportation of the machine later for service.
See "TRANSPORT" chapter earlier in this manual for safety
instructions before transporting the machine.
Required equipment (not included)
Full size pickup truck or trailer with the bed that is large
enough to fit the machine.
3 ratchet tie-down straps.
Measuring tape.
Bungee cord(s) or rope.
2 people.
2 dual runner folding ATV ramps with at least 661 lbs (300 kg) capacity and 12" (30.5 cm) width. The length of the
ramp is determined by how high the truck/trailer bed is above ground.
For your safety, make sure that the incline of the ramps is less than 15° whenever possible.
WARNING: To reduce the risk of injury and property damage, NEVER drive the machine up or down the ramp.
WARNING: Heavy object. Two people are required to load/unload the machine.
To load the machine onto a truck or trailer
a. Make sure your truck or trailer is parked on a level surface. The rear of the machine should face the rear of the
truck/trailer.
62
56-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT4200S/ZT4200S-FC
32
Mower Status Indicator
LED Light Button
33
Straps
Fuel Gauge
MODE
CCS Button
Ramps

Publicité

loading

Ce manuel est également adapté pour:

Zt4200s-fc