Signs And Symbols; Notes; Safety Notes - Beurer TL 100 Mode D'emploi

Masquer les pouces Voir aussi pour TL 100:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17

2. Signs and symbols

The following symbols appear in the Instructions for use or on the device.
Read the Instructions for use.
Warning notice indicating a risk of injury or
damage to health.
Warning
Safety note indicating possible damage to the
unit/accessory.
Important
SN
Serial number
The CE labelling certifies that the product
complies with the essential requirements of
Directive 93/42/EEC on medical products.
Disposal in accordance with the Waste Elec-
trical and Electronic Equipment EC Directive
– WEEE
Direct current

3. Notes

Please read these instructions for use carefully and keep them for later use, be sure to make them accessible to
other users and observe the information they contain.

Safety notes

Warning
• This daylight therapy lamp is only intended for radiation on human bodies.
• Before use, ensure that there is no visible damage to the device or accessories and that all packaging
material has been removed. If you have any doubts, do not use the device and contact your retailer or the
specified Customer Services address.
• Ensure that the daylight therapy lamp is positioned on a stable base.
• The device must only be connected to the mains voltage that is specified on the type plate.
• Never submerge the device in water or other liquids and do not use it in the bathroom.
• Must not be used on people with disabilities, children under three years of age or people with reduced
sensitivity to heat (e.g. people with skin alternations due to illness), after taking pain relief medication,
alcohol or drugs.
• Keep packaging material away from children (risk of suffocation!).
• The device should not be covered, uncovered, or packed and stored when warm.
• Always unplug the mains part and allow the device to cool down before touching it.
• Do not touch the device with wet hands when it is plugged in and do not allow water to spray on the de-
vice. Only operate the device if it is completely dry.
• Ensure that you only insert and remove the mains part with dry hands and that you only press the ON/
OFF button with dry hands.
• Keep the mains cable away from hot objects and naked flames.
• Danger of strangulation due to excessively long cables.
• Protect the device from heavy impact.
• Do not pull the mains part out of the socket using the mains cable.
• If the mains part or its housing is damaged, this must be replaced by Customer Services or the retailer, as
a special tool is needed for repair.
• Disconnection from the power supply network is only guaranteed when the mains part is unplugged.
Storage
Operating
Note on important information.
Note
Manufacturer
Protection class II
OFF/ON
Protected against solid foreign
objects 12.5 mm in diameter
IP21
and larger, and against vertically
falling drops of water
11
Permissible storage temperature
and humidity
Permissible operating tempera-
ture and humidity

Publicité

Table des Matières
loading

Table des Matières