Dea NET24N Notice D'emploi Et Avertissements page 34

NET24N
9.2 Learning
1. Scroll down the parameters with [+] and [-]
keys until you visualise P005;
2. Confirm by pressing on the [OK] key;
3. When the symbol "LEAr" appears, press on
any key of the transmitter you want to memo-
rize;
4. The display visualizes the number of the trans-
mitter just memorized and then "LEAr";
5. Memorize all necessary transmitters repeat-
ing this procedure from step 3;
6. Wait 10 seconds before quitting the memori-
zation mode, display shows now "- - - -".
Warning: In the case of rolling code remotes,
the receiver can be put into learning mode by
pressing the hidden button on a remote control
previously learned.
Warning: When using personalized transmitters,
after entering P005 the learning of the first
personalized transmitter is possible only by
pressing its hidden button. Afterwards, only
transmitters personalized
encryption key can be memorized (through the
usual procedure), unless a memory reset is
carried out (P004).
Warning: If poor radio range is experienced, it
is recommended to connect the antenna of the
flashing light (if present) or to install a tuned
external antenna.
10 Adjustment of operating parameters
If you need to modify the operating parameters (force, speedness
etc..):
1. Scroll down the parameters until you visualize the desire param-
eter (i.g. P032);
2. Confirm by pressing on the [OK] key;
3. By pressing on [+] and [-], set up the desired value;
4. Confirm by pressing on the [OK] key (display shows the param-
eters previously selected).
For the complete list of the "Operating Parameters" See the table
on page. 38.
11 Programming complete
WARNING At the end of the programming procedure, use the buttons [+] and [-] until the appearance of the symbol "- - - -", the operator
is now ready again for new manoeuvres.
To perform any "Advanced Programming" operations (cancellation of the remotes, configuration inputs, etc. ..), see on page 33.
32
with the same