Programming Auto Heat Up; Stop & Go Function; Recall Function; Keep Warm Function - Novy Easy 1851 Mode D'emploi

selected and counting down starts.
Turn off automatically at the end of the cooking time:
As soon as the selected cooking time is up, the display will flash
‐‐‐
, a beep will be heard. To stop the audible signal and the
flashing, press [ ] on the timer.
000

4.3.6 Programming auto heat up

All cooking zones are equipped with an auto heat up function.
The cooking zone will initially operate at full power for a certain
amount of time before automatically reducing to the selected
power level.
Programming auto heat up:
Activating auto heat up
Glide your finger over the slider to (for example)
7
and hold for 3 seconds
Switching auto heat up off
Glide your finger over the slider
Auto heat up table
Set value for cooking time
1
2
3
4
5
6
7
8
9
4.3.7 Stop & Go function
This function temporarily interrupts the activity of the hob and
allows a restart with the same settings.
Turning Stop & Go on and off:
Switching on
II
Press for 2 seconds until it blinks.
Switching off
II
Press for 2 seconds.
Select a cooking zone with the zone selection
key
Display
7 A
Display
0 9
to 0‐9
Auto heat up function
Time (min:sec)
0:40
01:12
02:00
02:56
04:16
07:12
02:00
03:12
--:--
Display
I I
0‐9

4.3.8 Recall function

After turning the hob off
to recall the last selected settings: (this up to a maximum of 10
seconds)
– State of all cooking zones (power)
– Minutes and seconds of the programmed cooking zones by
the timers
– "Automatic cooking" function

– Keep warm function

The recall procedure is as follows:
– Push the control key
II
– Push before the flashing stops.
The previous settings are now active again.
4.3.9 Keep warm function
This function makes it possible to automatically reach and
maintain a temperature of 70°C .
This prevents pans overflowing or your food sticking to the
bottom of the pans.
Switching the keep warm function on and off:
Switching on
Select the zone using the zone selection button
Press
Switching off
Select the zone using the zone selection button
Press
The maximum duration of the keep warm function is 2 hours.

4.3.10 Bridge function

This function allows you to join the 2 left and 2 right zones
so they operate as 2 large flex zones. This function can be
activated manually, or automatically when a large pot/pan be
placed on the cooking surface.
Manual activation
Simultaneously press the 2 zone selection
keys of the 2 flex zones A1, A2 or B1, B2 to be
shared.
Automatic activation
Place a pot on the zones A1, A2 or B1, B2.
Then press the flashing icon
Increase the power
Slide your finger over the left slider until you
reach the desired power level, both flex zones
display the chosen power.
Switch bridge function off
Simultaneously press the 2 zone selection keys
of the 2 combined zones.
– 50 –
, it is possible
for 2 seconds.
Bridge function:
to confirm.
Display
0
Display
0
0‐9
0