Extractor Controls; Switch On And Off; Cleaning Indications; Grease Filter Cleaning Indicator - Novy Easy 1851 Mode D'emploi

5.4 Extractor controls

5.4.1 Switch on and off

Extractor
Increase extraction power
Press the zone selection button of the extractor
Slide over the "SLIDER"
Reduce extraction power
Press the zone selection button of the
extractor
Slide over the "SLIDER"
Switch off extractor
Press the zone selection button of the extractor
Slide over the "SLIDER"
Switch on automatic extraction
Press the zone selection button of the extractor
and keep pressed for 3 seconds
Switch off automatic extraction
Press the zone selection button of the
extractor and keep pressed for 3 seconds
Switch on delay function
Press .
Switch off delay function
Press again.
Automatic extraction
This function automatically adjusts the extraction power
depending on the power used of the cooking zone(s).
When this function is active when switching off the appliance, it
is automatically activated when switching on again.
Tip: the extraction power can be changed quickly by sliding
over the "SLIDER".
This action temporarily halts the automatic extraction. The
automatic extraction is reactivated the next time the appliance
is switched on.
Delay function: This function starts up after the cooking stops.
With it, all the last cooking vapours are extracted from the
kitchen for a pre-set time by the downdraught extraction tower
at low extraction power. The delay time is set by default to 10
minutes in extraction mode. It is advisable always to carry out
this function completely. After the end of the delay time, the
extractor switches off automatically.
The delay function can be switched off manually by pressing
the button again.

6 CLEANING INDICATIONS

6.1 Grease filter cleaning indicator

Display The grease filter should be cleaned after 20 hours of cooking.
This is automatically indicated by the appliance.
0 ‐ 9
When the appliance is switched on "F" will appear on the timer
display, after 20 hours of cooking.
9 ‐ 0
Reset van de vetfilter indicatie
Press
F
0

Follow the cleaning instructions set out in the
chapter Cleaning and Maintenance.
A
0

7 COOKING ADVICE

Quality of the pots and pans
A 1
or
Suitable cookware, pots and pans include: steel, enamelled
steel, cast iron, stainless steel with magnetic base, aluminium
LED
with magnetic base (±100mm min). Unsuitable pans include:
goes out
aluminium and stainless steel without magnetic base, copper,
brass, ceramics, porcelain. The manufacturers will state
whether their products are suitable for induction.
In order to ensure your pans are suitable:
– Pour a little water in a pan and place it on an induction
cooking zone set to
few seconds.
– Hold a magnet to the base of the pan. The magnet should
stick.
Some cooking pots hum when they are placed on an induction
cooking zone. This does not mean the device is faulty, and it
will not affect operation. This noise decreases when you adjust
the power.

Lift the pans up when you want to move them to
avoid stains and scratches.
– As often as possible, prepare meals with the pan lid on.
– 52 –
Grease filter
for 3 seconds until you hear a beep.
9
. The water should be hot within a
Display
F