Power Function; Timer Function - Novy Easy 1851 Mode D'emploi

4.3.4 Power function

The Power function increases the power rating of the selected
P
cooking zone. If this function is activated, these cooking zones
will be subjected to considerably higher power for 10 minutes.
The Power function is designed to quickly heat large quantities
of water, for pasta for example.
Switching Power on and off:
Switch on power
Glide your finger over the slider to the end or
push the end of the slider
Switch off Power
Glide your finger over the slider
Management of maximum power:
The hob is divided into 2 separate heating groups.
B2
B1
If this power limit is exceeded when switching to a high
selected cooking heat or switching the power function on, the
power management module reduces the cooking position of
the relevant cooking zone. This cooking zone will first flash,
and it is then automatically reduced to the maximum possible
cooking heat
The maximum individual power for each zone is 3000 W.
If simultaneous cooking is taking place on zones A1 and A2 or B1
and B2, the power of 3700 W is divided between these 2 zones
A1 and A2 or B1 and B2.
Cooking zone in cm
A1 24 x 21
A2 24 x 21
B1 24 x 21
B2 24 x 21
Power limit
Selected cooking zone with Power function
Power limit activated
[9] reduced to [8] and flashes
In order to be able to make use of the maximum possible power
for 2 zones at the same time, use a combination of zone A1 or
A2 and B1 or B2.
Display
P
9‐0
A2
A1
Power (W)
Normal: 2100
Power: 3000
Display
P
8

4.3.5 Timer function

The timer function allows all cooking zones to be used
simultaneously for different periods of time (0 to 1H59 minutes)
for each zone.
Setting or changing the cooking time
Select the power by gliding your finger over the
slider
Select the timer
Press the timer icon above the zone selection
key for the required cooking zone
Reduce the time
Press [–] on the timer
Increase the time
Press [+] on the timer
After a few seconds the LED
has been selected and the countdown has begun.
Switch off the timer function
Select the timer
Press the timer icon above the zone selection
key for the required cooking zone
Stop the timer
Keep pressing [–] on the timer until the timer
000
displays .
If different timers are to be activated on multiple zones, this
operation must be repeated several times. The activated timer
indication no longer lights up above the relative cooking zone.
The timer can also be used as an independent cooking alarm
without selecting a cooking zone. If the hob is to be switched
off, the independent cooking timer will continue until the end of
the set time.
Using the timer without cooking:
Timer without cooking
Switch on the hob.
Press for 2 seconds.
Wait 10 seconds
Select the timer
Press the timer indicator [000]
Reduce the time
Press [–] on the timer
Increase the time
Press [+] on the timer
After a few seconds the timer display stops flashing. The time is
– 49 –
Timer function
0 0 1‐
1 5 9...
0 6 0‐
0 5 9...
no longer flashes. The time
0 0 0
0 0 0
0 6 0‐
0 5 9...
0 0 1‐
0 0 2...
Display
1‐P
Display
Display