Before You Begin; Parts Included; Tools And Parts Needed; Power Requirements And Grounding - Bosch Hef1050Mu Instructions D'installation

2 Before you begin

Before you begin

Read these instructions before you begin to install your
Before you begin
appliance.
This Installation Instructions covers several models. All
graphics are representative. Your appliance may vary in
appearance and features.
2.1 Parts included
After unpacking all the parts, check for any damage in
transit and for completeness of delivery.
¡ Anti-tip bracket with 2 cross-head screws ³⁄₁₆" x 2" (4.8 x
50 mm)
¡ Terminal lugs; for use with hard-wired installations (not
required for Canadian installations)
2.2 Tools and parts needed
Prepare these tools and accessories before you start to
install your appliance.
Tools
¡ Pencil
¡ Measuring tape
¡ Level
¡ Knife
¡ Cross head screwdriver
¡ Flathead screwdriver
¡ 1¼" wrench
¡ Pipe wrench
¡ Drill and 3/16" masonry drill bit for concrete screws
¡ Safety gloves
¡ Safety glasses
¡ Cloth or cardboard to protect floor
Parts
¡ 40 or 50 Amp power supply cord kit with strain relief;
depending on local codes. (Not necessary for Canadian
installations, cord is preinstalled at factory.)
Additional parts needed for hard-wired installations
¡ Flexible conduit
¡ Torque wrench
2.3 Power requirements and grounding
The outlet must be properly grounded in accordance with
all applicable codes.
3 Removing the packaging

Removing the packaging

Removing the packaging Cut the box straps.
1.
Open the top of the carton and remove the top frame.
2.
Place the unit in front of the cabinet where it is to be
3.
installed. The unit should be in line with the cabinet
cutout.
Leave the unit on the packaging base until it is ready to
be lifted into the cabinet cutout.
Remove the carton by lifting it up and off the unit.
4.
Alternatively you can carefully cut along the cut line on
the back left side of the carton with a blade shorter than
3/4" (20 mm).
Remove all internal protective packaging, racks,
5.
accessories, and instruction manuals from the oven
cavity.
4 Installation requirements

Installation requirements

Read these instructions to prepare the installation space
Installation requirements
for your appliance.
4.1 Appliance dimensions
4.2 Location requirements
CAUTION
To prevent possible damage to cabinets and cabinet
finishes:
Use only materials and finishes that will not discolor or
▶
divide into layers.
Materials should be able to withstand temperatures up
▶
to 194°F (90°C).
Heat and moisture resistant adhesive must be used if
▶
the product is to be installed in laminated cabinetry.
Check with the product manufacturer to ensure
▶
materials meet these requirements.
¡ The electrical supply should be within the zones shown
in the image on clearance requirements.
¡ Any opening in the wall behind the appliance and in the
floor under the appliance shall be sealed.
¡ To eliminate the risk of burns or fire by reaching over
heated surface units, cabinet storage space located
above the surface units should be avoided. If cabinet
storage is to be provided, the risk can be reduced by
installing a hood that projects horizontally a minimum of
5" (12.7 cm) beyond the bottom of the cabinet.
Before you begin en-us
7