Before You Begin
Tools and Parts Needed
Phillips head screwdriver
▯
Slotted screwdriver 1/8" (3,5 mm)
▯
Adjustable wrench
▯
Tongue and groove pliers
▯
Socket or flat wrench 3/8" (10 mm) or tongs
▯
Socket or flat wrench 7/8" (22 mm) or tongs
▯
Drill with 5/16" (8 mm) bit
▯
Pencil
▯
Tape measure
▯
Note: Additional materials may be necessary for
installation in solid surface countertops. Contact the
countertop manufacturer.
Parts Included
30":
* Attached to the appliance.
8
B e f o r e Y o u B e g i n
36":
* Attached to the appliance.
Removing Packaging
See the diagram on the packaging.
If straps are present, cut the straps.
▯
Cut plastic down back of unit making sure not to cut
▯
the unit.
Remove plastic film.
▯
Lift the cardboard carton from the top of the range and
▯
dispose of.
Remove the corner posts, making sure that any other
▯
packing materials running between the corner posts
are also removed.
Remove all internal packaging and tape.
▯
The rear vent trim is nested in the styrofoam
▯
packaging for shipping purposes. Do not throw away.