Signature SFC3000STW Manuel D'utilisation page 65

8. Change screw hole covers on middle cover plate
from left to right(as shown in figure below).
9. Lay the refrigerator on soft foam packaging or
similar material.
Remove both adjustable bottom feet parts1, then
remove the lower hinge part 2by unscrewing the
special flange self-tapping screws3.
10.Remove part 1 from the lower hinge part(right),
loose out the lower hinge pin, change it to the
reverse hole site, and then tighten into position,
then install part 1 on the lower hinge pin.
- 14 -