Publicité
Les langues disponibles
Les langues disponibles
Note:
A dirty mop cloth will affect the mopping performance.
Clean it before use.
D7-2—Stick the mop cloths on the mounts
flat in place.
Robot Sensors
D8
* Clean as required.
Use a soft, dry cloth to wipe and clean all
sensors, including:
D8-1—Reactive Tech Obstacle Avoidance Sensor
D8-2—Wall Sensor
D8-3—Communication Sensor
D8-4—Carpet Sensor
D8-5—Cliff Sensors
Moving Dock
D9
To move the dock, grip the cord storage
slot on the back with one hand and the
inner side of the front board with the other
hand. Do not lift the dock base, water tank
handles, or dust container cover directly to
prevent the dock from falling off.
Dirty Water Tank
D10
* Clean as required.
Open the dirty water tank lid and pour out the
dirty water. Fill the tank with clean water, close
the lid, lock the latch, and shake. Pour out the
dirty water. Lock the lid and reinstall the tank.
Notes:
• To avoid deformation, only use cold water.
• If any water stains remain on the outside of the water tank,
wipe them with a soft, dry cloth before reinstalling the tank.
Charging Contacts
D11
* Clean as required.
Use a soft, dry cloth to wipe the charging
contacts on the robot and the dock.
Replacing Disposable Dust Bag
D12
* Replace as required.
D12-1—Remove the dust container cover.
Note:
To prevent the dust container cover from falling
and hitting the robot, remove the cover with both
hands, one on each side.
D12-2—Remove the disposable dust bag
and discard it.
Notes:
• The dust bag handle seals the bag on removal to
prevent leakage.
• Always install a dust bag before putting back the dust
container cover to avoid auto-emptying without the
bag. You can also disable auto-emptying in the app.
D12-3—Clean the filter with a dry cloth,
insert a new disposable dust bag
into the slot all the way in, and
spread it evenly.
Note:
Make sure the disposable dust bag is properly
installed to avoid waste escaping and damaging the dock.
D12-4—Reinstall the dust container cover
in place to make sure the dust
container is securely sealed.
Cleaning Tray
D13
* Clean as required.
D13-1—Remove the cleaning tray.
13
D13-2—Rinse the cleaning tray and the filter
with water.
D13-3—Reinstall the cleaning tray.
Basic Parameters
Robot
Model
RRE0PEE
14.4 V/5200 mAh (TYP)
Battery
lithium-ion battery
Rated Input
20 V 1 A
Note:
The serial number is on a sticker on the underside
of the robot.
Empty Wash Fill Dock
Model
EWFD36LRR
Rated Input Voltage 120 V~
Rated Frequency
60 Hz
Rated Input (Dust
5.5 A
collection)
Rated Input
0.5 A
(Non-dust collection)
Rated Output
20 V 1 A
Publicité
