Kuppersbusch VITRO-EXPRESS Premium Line 850 KCF 0302 Mode D'emploi Et Instructions De Montage page 27

Connection
For the electrical installation, the connection space must be made
accessible.
- Remove lower front panel u: Undo screws 1 and pull the metal
sheet downwards.
- Remove front panel b: Undo screws 2 and pull the metal sheet
to the left.
Additionally when installing on customer pedestal
- Remove cover plate a: Undo screws from below and remove plate.
Electrics
The terminal box e is accessible from the front. It is located behind
the front panels b and u.
Connect the appliance as shown in the applicable wiring diagram.
=
The connection cable leading through the appliance must be fully
sheathed from the connection point up to the entrance to the
terminal box!
The number of the applicable wiring diagram is on the appliance
identification plate (see page 2).
The wiring diagrams for the basic version are part of these instructions.
Wiring diagrams for special versions are provided in the connection
space of the appliance.
Compare the numbers of the wiring diagrams with the appliance
identification plate. For special versions keep the wiring diagrams with
these instructions and identify the wiring diagrams which do not apply
accordingly!
=
After completing all installation work, remount all covers and
panels and screw them tight. Only then should the customer's all-
pole cut-off device (e.g. fuse switch-disconnectors) be closed.
W.Nr. 07 25 35 27