Standard Accessories; Applications; Battery Removal/Installation - Hitachi WH 14DCAL Mode D'emploi

8. Do not put or subject the battery to high
temperatures or high pressure such as into a
microwave oven, dryer, or high pressure container.
9. Keep away from fire immediately when leakage or
foul odor are detected.
10. Do not use in a location where strong static
electricity generates.
11. If there is battery leakage, foul odor, heat generated,
discolored or deformed, or in any way appears
abnormal during use, recharging or storage,
immediately remove it from the equipment or
battery charger, and stop use.
SPECIFICATIONS
POWER TOOL
Model
No-load speed
Capacity
Tightening torque (Maximum)
Rechargeable battery
Weight
CHARGER
Model
Charging voltage 7.2 – 18 V
Weight
The UC18YG charger is only for charging Ni-Cd batteries.

STANDARD ACCESSORIES

1 Battery .......................................................................... 2
2 Charger ......................................................................... 1
3 Plastic case ................................................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Battery (BCL1430)
UC18YRL UC18YG
7.2 – 18 V
0.6 kg 0.3 kg
CAUTION
1. If liquid leaking from the battery gets into your
eyes, do not rub your eyes and wash them well
with fresh clean water such as tap water and contact
a doctor immediately.
If left untreated, the liquid may cause eye-problems.
2. If liquid leaks onto your skin or clothes, wash well
with clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
3. If you find rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using
the battery for the first time, do not use and return it
to your supplier or vendor.
WH14DCAL
0-2100 min
M4 – M8 (Small screw)
M4 – M10 (Ordinary bolt)
M4 – M8 (High tension bolt)
BCL1430: Li-ion 14.4 V
(3.0 Ah 4 or 8 cells)
1.6 kg
2. Battery (EB14B)
Optional accessories are subject to change without notice.

APPLICATIONS

Driving and removing of machine screws, wood
screws, tapping screws, etc.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
WH14DY
–1
50 N·m
EB14B: Ni-Cd 14.4 V
(2.0 Ah 12 cells)
1.9 kg
English
6