Charging The Battery - HAIRCUT TH25PRO Guide De L'utilisateur

EN
3 Use

3.1 Charging the battery

It is essential to charge the battery for about 2 hours before using the clippers for
the first time.
Charge the clippers at least once during the year following the date of delivery.
The battery reaches its full capacity after 3 or 4 charging cycles.
During use, the
(Fig. 3a). Follow the instructions below to charge the battery.
For the two charging modes below, exclusively use power pack
ZDJ045100EU (see Fig. 1-N and § 5).
When charging, it is recommended to switch off the clippers (On/Off
button off, Fig. 1-D).
Charging clippers from mains
Insert the electrical lead into the socket of the clippers (Fig. 3b).
Connect the power pack (Fig. 1-N) to a mains power socket.
When charging, the LCD screen comes on with the
indicates charge (Fig. 3d). Charge is completed when the bargraph is complete.
The autonomy is then about 300 minutes.
When completely charged, disconnect the power pack. The clippers can now be
used without the electrical lead.
Charging the battery on the charge stand
Insert the electrical lead into the charge stand socket (Fig. 3c).
Connect the power pack (Fig. 1-N) to a mains power socket.
Put the clippers on the charge stand and proceed as described above.
When completely charged, the clippers can be used without the electrical lead.
3.2 Operation
When first used, lubricate the blades by applying a drop of oil to the points shown
(see § 3.5 and Fig. 5c).
Switching on/off
Switch the clippers on by pressing the On/Off button (Fig. 1-D). The LCD screen
comes on.
charge light flashes when the battery is almost discharged
24
symbol, the bargraph