Charging The Battery - HAIRCUT TH34 Guide De L'utilisateur

EN
3 Use

3.1 Charging the battery

It is essential to charge the clipper battery for about 2 hours before using the
clippers for the first time.
Charge the clippers at least once during the year following the date of delivery.
The battery reaches its full capacity after 3 or 4 charging cycles.
 For the two charging modes below, exclusively use power pack
ZDJ045100EU (see Fig. 1-N and § 5).
 When charging, it is recommended to switch off the clippers (On/Off
button off, Fig. 1-E).
Charging clippers from mains
 Insert the electrical lead into the socket of the clippers (Fig. 3a).
 Connect the power pack (Fig. 1-N) into a mains power socket.
 When charging, the red light (Fig. 1-M) comes on. The battery is fully charged
when the LCD indicates 120. The autonomy time is then 120 minutes.
 When completely charged, disconnect the power pack. The clippers can now be
used without power lead.
Charging the battery on the charge stand
 Insert the electrical lead into the charge stand socket (Fig. 3b).
 Connect the power pack (Fig. 1-N) into a mains power socket.
 Put the clippers on the charge stand (Fig. 1-V) and proceed as described above.
 When completely charged, the clippers can be used without the electrical lead.
3.2 Operation
When first used, lubricate the blades by applying a drop of oil to the points shown
(Fig. 7).
Switching on/off
 Switch the clippers on by pressing the On/Off button (Fig 1-E). The red button
comes on. The "On" indicator (Fig. 1-L) lights up.
 To stop the clippers, press the On/Off button again (Fig. 1-E).
24