Safety Instructions; Electrical Hazards - HAIRCUT TH25PRO Guide De L'utilisateur

1.5 Safety instructions

The clippers are designed for use in a
hairdresser's salon, in compliance with the
following points.

Electrical hazards

Make sure that the power supply
voltage shown on the nameplate
(Fig. 2) corresponds to that of your
electrical installation.
stop using the clippers immediately.
Contact the dealer or his after-sales service
to obtain a replacement lead.
In the event of failure of the charge stand or
power pack, it must be replaced by a model
that is identical in all respects.
Regularly check the condition of
the electrical lead. If the lead
shows any signs of damage,
The electrical lead must always
be fully unrolled before it is
connected to a power socket.
17
EN