Husqvarna K 1270 II Manuel D'utilisation page 37

Problem
The cutting blade rotates at
idle speed.
The cutting blade does not
rotate when the operator
throttles up.
The product has no power
when the operator tries to
throttle up.
The vibration levels are too
high.
The temperature of the prod-
uct is too high.
The engine decreases in
power or in speed.
There is much dust during
operation. You can see dust
in the air.
The SmartGuard does not
move freely.
The SmartGuard does not re-
tract when the product is re-
moved away from the work
piece.
1631 - 001 - 04.05.2021
Cause
The idle speed is too high.
The clutch is defective.
The belt is too loose or defective.
The clutch is defective.
The cutting blade is installed incor-
rectly.
The air filter is clogged.
The fuel filter is clogged.
The fuel tank flow is blocked.
The cutting blade is installed incor-
rectly.
The cutting blade is defective.
A vibration damping unit is defective.
The air intake or the cylinder flanges
are blocked.
The drive belt tension is not suffi-
cient.
The clutch is defective.
The air filter is clogged.
The water supply or water pressure
is not sufficient.
The moving parts of the SmartGuard
are clogged.
The springs of the SmartGuard does
not operate correctly.
Possible solutions
Adjust the idle speed.
Speak to your service agent.
Tighten the belt or replace the belt with a
new one.
Speak to your service agent.
Make sure that the cutting blade is correctly
installed.
Examine the air filter. If it is necessary, re-
place it.
Replace the fuel filter.
Speak to your service agent.
Make sure that the cutting blade is correctly
installed and that it is not damaged. Refer to
To install the cutting blade on page 14 .
Replace the cutting blade and make sure
that it is not damaged.
Speak to your service agent.
Clean the air intake and the cylinder flanges.
Examine the belt. Adjust the tension.
Always cut at full throttle.
Examine the clutch. Speak to your service
agent.
Examine the air filter. Refer to
the air filter on page 35 .
Do a check of the water supply to the prod-
uct.
To do a check of the water supply
Refer to
system on page 36 .
Clean the moving parts.
Do a check of the springs. Clean the springs.
To examine
37