Husqvarna K 1270 II Manuel D'utilisation page 12

striking an unintended object. Do not use a
damaged cutting blade. After inspecting and
installing the cutting blade, position yourself
and bystanders away from the plane of the
rotating cutting blade and run the power tool
at maximum no load speed for one minute.
WARNING:
manufacturer gives warnings and
recommendations for the operation and
correct maintenance of the cutting blade.
Those warnings are supplied with the cutting
blade. Read and obey the instructions that
are supplied with the cutting blade.
Applicable cutting blades
WARNING:
and abrasive blades for concrete and metal.
Do not use blades with serrations such as
circular wood cutting blades or blades with
carbide tips. The risk of kickback is
increased and carbide tips can come off and
be thrown at high speed. This can result in
injury or death.
WARNING:
for any other materials than what it was
intended to cut.
WARNING:
that comply with applicable national or
regional standards, for example EN12413,
EN13236 or ANSI B7.1.
WARNING:
with a rated speed value lower than that of
the product. The rated speed value of the
cutting blade is marked on the cutting blade,
and that of the product is marked on the
blade guard.
12
The cutting blade
Only use diamond blades
Never use a cutting blade
Use only cutting blades
Do not use a cutting blade
100 m/s
XXXX rpm
Note:
Many cutting blades that can be attached to this
product are made for stationary saws. The rated speed
value of those cutting blades is too low for this product.
CAUTION:
with thickness exceeding maximum
recommended thickness. Refer to
data on page 39 .
• Cutting blades applicable to this product are
available in two basic models; bonded abrasive
blades and diamond blades.
• Make sure that the cutting blade has the correct
center hole dimension for the installed arbor
bushing.
Cutting blade vibration
CAUTION:
too much force, the cutting blade can
become too hot, bend and cause vibrations.
Use the product with less force. If the
vibrations continue, replace the cutting
blade.
Bonded abrasive cutting blades
WARNING:
abrasive cutting blades together with water.
Moisture decreases the strength in the
bonded abrasive cutting blade and the
cutting blade can break and cause injury.
A bonded abrasive cutting blade is made of small
abrasive grains joined with an organic or vitrified bond,
molded with fabric reinforcements, which prevents the
cutting blade from breaking during high speed operation.
Bonded abrasive cutting blades for different
materials
Note:
Make sure that you use the correct cutting
blades for rail cutting.
Do not use cutting blades
Technical
If you use the product with
Do not use bonded
1631 - 001 - 04.05.2021