Husqvarna K 1270 II Manuel D'utilisation page 29

2. Make sure that the spark plug cap and ignition cable
are not damaged to prevent the risk of electrical
shock.
3. Clean the spark plug if it is dirty.
4. Make sure that the electrode gap is 0.5 mm.
5. If it is necessary, replace the spark plug.
To do a general inspection
• Make sure that all nuts and screws on the product
are tightened correctly.
To replace the drive belt
WARNING:
without all guards and covers installed.
1631 - 001 - 04.05.2021
Do not start the product
1. Turn the bolt for the cutting blade counterclockwise
with a wrench to remove the cutting blade.
2. Loosen the 2 bolts (A) and then the adjuster screw
(B) to release the belt tension.
B
A
3. Remove the 2 bolts.
29