Husqvarna K 1270 II Manuel D'utilisation page 15

Masquer les pouces Voir aussi pour K 1270 II:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING:
gloves when you assemble the product.
1. Examine the flange washers and the spindle shaft.
To examine the spindle shaft and the flange
Refer to
washers on page 14 .
2. Push back and hold the SmartGuard in the retracted
position.
Note:
This step only applies to K 1270
SmartGuard.
3. Put the cutting blade on the arbor bushing (A)
between the inner flange washer (B) and the flange
washer (C). Turn the flange washer until it holds on
to the shaft.
B
4. Put a tool into the hole in the front belt guard and
turn the cutting blade until the shaft is locked.
1631 - 001 - 04.05.2021
Always use protective
A
C
5. Tighten the cutting blade bolt to 25 Nm/18.5 ft-lb.
To reverse the cutting head (K 1270 II)
WARNING:
head reversed if a standard procedure is not
possible.
The product has a reversible cutting head that lets you
cut near a wall or at ground level. Only cut with the
cutting head reversed if a standard procedure is not
possible. If a kickback occurs, it is more difficult to
control the product if the cutting head is reversed. The
distance between the cutting blade and the center of the
product is longer, which means that the handle and the
cutting blade do not align. This has a negative effect on
the balance in the product and it is more difficult to hold
the product if the cutting blade is pinched or stalled in
the kickback zone. Refer to
WARNING:
is off and that the stop switch is in the STOP
position.
WARNING:
gloves when you assemble the product.
1. Remove the cutting blade, the front belt cover and
the cutting head. Refer to steps 1-5 in
drive belt on page 29 .
2. Remove the 2 screws and nuts that hold the spray
nozzle.
Only cut with the cutting
Kickback on page 16 .
Make sure that the engine
Always use protective
To replace the
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

K 1270 ii railK 1270 smartguard

Table des Matières