Adjusting The Cutting Depth - Festool TSC 55 KEB Notice D'utilisation D'origine

Speed range per material
Plaster- and cement-bonded chipboard
and fibreboard
Aluminium panels and profiles up to
15 mm
Plastics, fibre-reinforced plastics, paper
and fabric
Acrylic glass
Current limiting
Current limiting prevents excessive current
consumption under extreme overload, which
can lead to a decrease in the motor speed. The
motor immediately restarts after the load is re­
moved.
Brake
The saw comes with an electronic brake. The
saw blade is stopped electronically within ap­
proximately two seconds of switching off the
machine.
Temperature cut-out
The power supply is restricted and the speed
reduced if the motor exceeds a certain temper­
ature. The power tool continues operating at re­
duced power to allow the ventilator to cool the
motor quickly. The power tool starts up again
automatically once the motor has cooled suffi­
ciently.
8.2

Adjusting the cutting depth

The cutting depth can be set at 0 ‑ 2-1/8"
(0 ‑ 55 mm) at the cutting depth stop [3-1].
The saw unit can now be pushed downwards as
far as the cutting depth that is set.
Cutting depth without guide rail
max. 2‑1/8" (55 mm)
Cutting depth with FS guide rail
+FS
max. 1‑15/16" (51 mm)
3
1–3
3-1
4–6
3–5
4–5
8.3 Setting the cutting angle
between 0° and 45°:
► Unscrew the rotary knobs [4-1].
► Swivel the saw unit to the desired cutting
angle [4-2].
► Tighten the rotary knobs [4-1].
Both positions (0° and 45°) are set at the
factory and can be readjusted by the cus­
tomer service team.
When making angled cuts, slide the view­
ing window/splinter guard to the highest
position.
To undercut -1° and 47°:
► Swivel the saw unit to the end position (0°/
45°) as described above.
► Pull out the release button [4-3] slightly.
► For -1° undercuts, also pull the release
button [4-4].
The saw unit engages in the -1°/47° position.
► Tighten the rotary knobs [4-1].
+FS
English
15