Capacity Display - Festool TSC 55 KEB Notice D'utilisation D'origine

English
2 A
1
2
1
2
2 B
klick
klick
Please note: The machine can only be op­
erated under the following conditions [2C]:
Both battery packs are used. Maximum power
with two battery packs (36 V).
Only the lower battery pack is used. Less power
with one battery pack (18 V).
2 C
14
7.1

Capacity display

The capacity display [1-13] indicates the charge
of the battery pack for approx. 2 seconds after
the button [1-11] is pressed:
* Recommendation: Charge the battery pack
before any further use.
Further information about the charger and
battery pack with capacity indicator can be
found in the corresponding operating
manual.
8 Settings
WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
8.1 Electronics
Smooth start-up
The electronically controlled smooth start-up
function ensures that the power tool starts up
smoothly.
Constant speed
The motor speed is electronically kept con­
stant. This ensures a uniform cutting speed
even when under load.
Speed control
You can continuously adjust the speed within
the speed range using the adjusting
wheel [1-12] (see "Technical data"). This ena­
bles you to optimise the cutting speed to suit
each surface.
Speed range per material
Solid wood (hard, soft)
Chipboard and hardboard
Laminated wood, blockboard, veneered
and laminated panels
Laminate, mineral materials
70‑100%
40‑70%
15‑40%
< 15% *
6
3–6
6
4–6