Adjusting The Cutting Depth; Adjust Pendulum Guard; Changing The Saw Blade; Dust Extraction - Festool HKC 55 EB Notice D'utilisation D'origine

Restart protection
The integral restart protection prevents the electric
power tool from automatically starting up again af-
ter an interruption in power when the ON/OFF
switch is pressed. In this case the electric power
tool must be switched off and then switched back
on again.
Temperature cut-out
When exceeding a certain engine temperature lev-
el, the machine power supply and speed are
capped. The power tool continues operating at re-
duced power to allow the ventilator to cool the mo-
tor rapidly. The power tool resumes to full perfor-
mance automatically once the motor has cooled
sufficiently.
7.2

Adjusting the cutting depth

The cutting depth can be set at 0 – 55 mm.

Press cutting depth adjustment [5-1].

Pull up or push down saw at main handle.
Cutting depth without guide rail/cross cut-
ting guide rail
max. 55 mm
Cutting depth with guide rail/cross cutting
+FS
guide rail
max. 51 mm
7.3 Adjusting the cutting angle
 The saw table must be on an even surface when
adjusting the cutting angle.
between 0° and 50°:

Open knob [6-2].

Swivel sawing unit to the desired cutting angle
[6-1].

Close knob [6-2].
 Both positions (0° and 50°) are set at the factory
and can be readjusted by the after-sales service
team.
 For angled cuts, the cutting depth is smaller
than the value displayed on the cutting depth
scale.
7.4

Adjust pendulum guard

Risk of injury! Sharp edges! The pendulum
guard swings back quickly in the event of
sudden release.
The pendulum guard [1-6]must only be opened
with the retractor lever.[1-4]
7.5

Changing the saw blade

WARNING
Risk of injury

Always disconnect the battery pack before per-
forming any type of work on the machine!
CAUTION
Hot and sharp tools
Risk of injury

Do not use insert tools that are blunt or defec-
tive.

Wear protective gloves.

Swivel saw to 0° position before replacing the
saw blade and set maximum cutting depth.

Position saw on motor cover when replacing[7-
1].

Turn lever [7-4] as far as stop.

Open the screw [7-8] using the Allen key[7-3].

Hold the pendulum guard open [7-7] only with
retractor lever [7-5].

Remove saw blade[7-9].

Insert new saw blade.
The direction of rotation of the saw blade
[7-10] and saw [7-6] must match.

Insert the outer flange [7-11]so that
the pin engages in the recess on the inner
flange.

Release retractor lever [7-5] and allow the pen-
dulum guard to swivel back [7-7] to its final po-
sition.

Tighten screw [7-8].

Reposition lever [7-4] .
7.6

Dust extraction

WARNING
Dust hazard

Dust can be hazardous to health. Always work
with a dust extractor.

Always read applicable national regulations be-
fore extracting hazardous dust.
Independent extraction

Secure the connection piece [8-2] of the dust
collection bag [8-3] at the extractor connector
with a clockwise rotation [8-1].
HKC 55 EB
GB
21