Settings; Adjusting The Cutting Depth; Changing The Saw Blade - Festool TS 55 REBQ Notice D'utilisation D'origine

English
7

Settings

WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
7.1 Electronics
The machine (TS 55 REBQ, TS 55 REQ) comes
with full-wave electronics with the following
properties:
Smooth start-up
The electronically controlled smooth start-up
function ensures that the power tool starts up
smoothly.
Constant speed
The motor speed is electronically kept con­
stant. This ensures a uniform cutting speed
even when under load.
Speed control
You can continuously adjust the speed within
the speed range using the adjusting
wheel [1-10] (see Technical data). This enables
you to optimise the cutting speed to suit specific
surfaces (see Section
Temperature cut-out
When exceeding a certain engine temperature
level, the machine power supply and speed are
capped. The power tool continues operating at
reduced power to allow the ventilator to cool
the motor rapidly. The power tool resumes to
full performance automatically once the motor
has cooled sufficiently.
Current limiting
Current limiting prevents excessive current
consumption under extreme overload, which
can lead to a decrease in the motor speed. The
motor immediately restarts after the load is re­
moved.
Brake
The TS 55 REBQ comes with an electronic
brake. The saw blade is stopped electronically
within approximately two seconds of switching
off the machine.
7.2

Adjusting the cutting depth

The cutting depth can be set at 0–55 mm at the
cutting depth stop [3-1].
The saw unit can now be pushed downwards as
far as the cutting depth that is set.
20
8.5 ).
Cutting depth without guide rail
Max. 55 mm
Cutting depth with FS guide rail
+FS
Max. 51 mm
7.3 Setting the cutting angle
between 0° and 45°:
► Unscrew the rotary knobs [4-1].
► Swivel the saw unit to the desired cutting
angle [4-2].
► Tighten the rotary knobs [4-1].
Both positions (0° and 45°) are set at
the factory and can be readjusted by
the customer service team.
When making angled cuts, slide the view­
ing window/splinter guard to the highest
position.
To undercut -1° and 47°:
► Swivel the saw unit to the end position (0°/
45°) as described above.
► Pull out the release button [4-3] slightly.
► For -1° undercuts, also pull the release
button [4-4].
The saw unit engages in the -1°/47° position.
► Tighten the rotary knobs [4-1].
7.4

Changing the saw blade

CAUTION
Risk of injury from hot and sharp tool
► Do not use any blunt or faulty tools.
► Wear protective gloves.
► Swivel the machine to 0° before replacing
the saw blade and adjust the maximum cut­
ting depth.
► Turn the lever [5-2]as far as the stop.
► Slide the safety lock [5-1] upwards and
push the saw unit downwards until it clicks
into place.
► Loosen the screw [5-5] using the Allen key
[5-3].
► Remove the saw blade [5-7].
► Insert a new saw blade.
The direction of rotation of the saw
blade [5-8] and machine [5-6] must match.
► Insert the outer flange [5-9] so that the pin
engages in the recess on the inner flange.
► Tighten the screw [5-5].
► Pull the lever [5-2]back.