Commissioning; Settings - Festool TSC 55 REB Notice D'utilisation D'origine

This power tool is suitable for use with
BP Festool battery packs of the same voltage
class.
7

Commissioning

7.1 Changing the battery pack
Removing the battery pack [2 A]
2 A
1
2
1
2
Inserting the battery pack [2 B]
2 B
klick
klick
Please note! Machine operation is on­
ly possible under the following condi­
tions [2 C]:
2 C
Both battery packs are used. Maximum power
with two battery packs (36 V).
Only the lower battery pack is used. Less power
with one battery pack (14.4 V/18 V).
7.2 Capacity display
The capacity display [1-12] automatically dis­
plays the charge state of the battery pack [1-6]
when the ON/OFF switch is actuated:
70 - 100 %
40 - 70 %
15 - 40 %
< 15 %
Recommendation: Charge
battery pack before further
use.
LED red – lit continuously:
battery, electronics or motor
temperature is outside the
permitted range.
LED red – flashing: indicates a
general fault, e.g. incomplete
contact, short circuit, battery
pack faulty, etc.
8

Settings

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
English
13