Service And Maintenance - Festool TSC 55 REB Notice D'utilisation D'origine

English
9.7 Speed setting for each material
Material
Solid wood (hard, soft)
Chipboard and hardboard
Laminated wood, blockboard, veneered and laminated panels
Plastics, fibre-reinforced plastics (FRP), paper and mesh
Acrylic glass
Gypsum and cement-bonded fibreboard
Aluminium panels and profiles up to 15 mm

10 Service and maintenance

WARNING
Risk of injury, electric shock
► Always remove the battery pack from the
power tool before performing any mainte­
nance or service work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
CAUTION
Certain cleaning agents and solvents are
harmful to plastic parts.
► Some of these include, but are not limited
to: Gasoline, Acetone, Methyl Ethyl Ketone
(MEK), Carbonyl Chloride, cleaning solu­
tions containing Chlorine, Ammonia, and
household cleaners containing Ammonia.
Customer service and repairs
must only be carried out by the
manufacturer or service work­
shops. Find the nearest address
at: www.festoolusa.com/service
Always use original Festool
EKAT
spare parts. Order no. at:
4
www.festoolusa.com/service
5
3
2
1
Observe the following instructions:
► Damaged safety devices and components
must be repaired or replaced in a recog­
nised specialist workshop, unless otherwise
indicated in the operating manual.
18
► To ensure constant air circulation, always
keep the cooling air openings in the housing
clean and free of blockages.
► Keep the contacts on the power tool, charg­
er and battery pack clean.
► Use an extractor on all openings of the pow­
er tool to remove chips and splinters.
► When working with plaster- and cement-
bonded fibreboards, clean the tool particu­
larly thoroughly. Clean the vents of the
power tool and on/off switch using dry, oil-
free compressed air. Otherwise, gypsum
dust deposits may build up inside the power
tool's housing and on the on/off switch and
harden when exposed to humidity. This may
impair the switching mechanism.
Check all warnings on the electric power tool
for readability and completeness. Replace
missing or illegible warnings.
10.1 Resharpened saw blades
The cutting depth of resharpened saw blades
can be adjusted accurately using the adjusting
screw [9-1].
► Adjust the cutting depth stop [9-2] to 0"
(with guide rail).
► Unlock the saw unit and push downwards
until it reaches the stop.
► Turn in the adjusting screw [9-1] until the
saw blade touches the workpiece.
Speed range
6
3-6
6
3-5
4-5
1-3
4-6