Environment; General Information; Information On Data Protection - Festool TS 55 REBQ Notice D'utilisation D'origine

• Parallel stop FS-PA and guide extension
FS-PA-VL
• Multifunction table MFT 3
• CMS-GE compact module system with
CMS-TS-55-R
10.1 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli­
cations and these are specially designed for
your Festool portable circular saw.
10.2 Guide system
The guide rail enables you to make clean, accu­
rate cuts while simultaneously protecting the
surface of the workpiece from damage.
In conjunction with the extensive range of ac­
cessories, exact angled cuts, mitre cuts and fit­
ting work can be completed with the guide sys­
tem. The option of attaching the guide rail se­
curely using clamps [9-5] ensures safer work­
ing conditions.
► Adjust the guide play between the saw table
and the guide rail using the two adjustable
jaws [9-1].
Bed in the splinter guard [9-3] before using
the guide rail for the first time:
► Set the machine speed to 6.
► Place the machine at the rear end of the
guide rail together with the complete guide
plate.
► Switch on the machine.
► Push down the machine slowly to the max.
preset cutting depth and cut along the full
length of the splinter guard without stop­
ping.
The edge of the splinter guard now corresponds
exactly to the cutting edge.

11 Environment

Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
EU only: In accordance with the European Di­
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly re­
cycling.
Information on REACH: www.festool.com/reach

12 General information

12.1 Information on data protection

The power tool contains a chip which automati­
cally stores machine and operating data. The
data saved cannot be traced back directly to an
individual.
The data can be read using special (contactless)
devices and shall only be used by Festool for
fault diagnosis, repair and warranty processing
and for quality improvement or enhancement of
the power tool. The data shall not be used in
any other way without the express consent of
the customer.
English
23