English
10 Accessories
Always use accessories and consumable mate
rials approved by Festool. See Festool
www.festool.co.uk.
The power tool may become unsafe and lead to
serious accidents if other accessories and con
sumables are used.
In addition to the accessories described,
Festool also provides a comprehensive range of
system accessories that allow you to use your
machine more effectively and in diverse appli
cations, e.g.:
•
Parallel stop PA-TS 60
•
Side-mounted cover, false joint ABSA-
TS 55/60
•
Kickback stop FS-RSP
•
Parallel stop FS-PA and guide extension
FS-PA-VL
•
Angle stop FS-WA and FS-WA/90°
•
Mobile saw table and work bench STM 1800
•
Multifunction table MFT/3
10.1 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli
cations and these are specially designed for
your Festool saw.
10.2 Guide system
The guide rail enables you to make clean, accu
rate cuts while simultaneously protecting the
surface of the workpiece from damage.
In conjunction with the extensive range of ac
cessories, exact angled cuts, mitre cuts and fit
ting work can be completed with the guide sys
tem. The option of attaching the guide rail se
curely using clamps [11-5] ensures safer work
ing conditions.
► Adjust the guide play between the saw table
and the guide rail using the two adjustable
jaws [11-1].
Bed in the splinter guard [11-3] before using
the guide rail for the first time:
► Set the machine speed to 6.
► Place the machine at the rear end of the
guide rail together with the complete guide
plate.
► Switch on the machine.
► Push down the machine slowly to the max.
preset cutting depth and cut along the full
length of the splinter guard without stop
ping.
The edge of the splinter guard now corresponds
exactly to the cutting edge.
30
Position the guide rail for sawing the
splinter guard on a test piece of wood.
10.3 Cross cutting guide rail
The cross cutting guide rail is designed for saw
ing wood and panel materials.
It enables precise and clean cuts, in particular
angled cuts can be performed simply and with
repeat accuracy. The saw automatically moves
back to the initial position after the sawing
process.
Observe the instructions in the operating man
ual for the FSK cross cutting guide rail
11 Environment
Do not dispose of the device in the
household waste! Recycle devices, ac
cessories and packaging. Observe appli
cable national regulations.
EU only: In accordance with the European Di
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly re
cycling.
Information about collection points for correct
disposal is available at
cling
.
Information on REACH:
reach
12 General information
Imported into the UK by
Festool UK Ltd
1 Anglo Saxon Way
Bury St Edmunds
IP30 9XH
Great Britain
12.1 Information on data privacy
The power tool contains a chip which automati
cally stores machine and operating data. The
data saved cannot be traced back directly to an
individual.
The data can be read in a contactless manner
using special devices and shall only be used by
Festool for fault diagnosis, repair and warranty
processing and for quality improvement or en
hancement of the power tool. The data shall not
be used in any other way without the express
consent of the customer.
www.festool.co.uk/recy
www.festool.co.uk/