Cross Cutting Guide Rail; Environment; General Information - Festool HK 85 EB Notice D'utilisation D'origine

Bed in the splinter guard before using the
guide rail for the first time[7-3]:
► Position saw with the entire guide plate at
the rear end of the guide rail.
► Swivel saw to 0° position and set maximum
cutting depth.
► Switch on saw.
► Slowly drop the splinter guard across the
entire length without setting down.
The edge of the splinter guard now corresponds
exactly to the cutting edge.

10.4 Cross cutting guide rail

The cross cutting guide rail is designed for saw­
ing wood and panel materials.
It enables precise and clean cuts, in particular
angled cuts can be performed simply and with
repeat accuracy. The saw automatically moves
back to the initial position after the sawing
process.
Observe the instructions in the operating man­
ual for the FSK cross cutting guide rail

11 Environment

Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
EU only: In accordance with the European Di­
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly re­
cycling.
Information on REACH: www.festool.com/reach

12 General information

Imported into the UK by
Festool UK Ltd
1 Anglo Saxon Way
Bury St Edmunds
IP30 9XH
Great Britain
English
27