Cross Cutting Guide Rail; Environment; General Information - Festool HKC 55 EB Notice D'instructions Originale

In conjunction with the extensive range of ac­
cessories, exact angled cuts, mitre cuts and fit­
ting work can be completed with the guide sys­
tem. The option of attaching the guide rail se­
curely using clamps [8-7] ensures safer work­
ing conditions.
► Adjust the guide play between the saw table
and the guide rail using the two adjustable
jaws [8-8].
Bed in the splinter guard before using the
guide rail for the first time[8-5]:
► Position saw with the entire guide plate at
the rear end of the guide rail.
► Swivel saw to 0° position and set maximum
cutting depth.
► Switch on saw.
► Slowly drop the splinter guard across the
entire length without setting down.
The edge of the splinter guard now corresponds
exactly to the cutting edge.
Position the guide rail for sawing the
splinter guard on a test piece of wood.

10.3 Cross cutting guide rail

The cross cutting guide rail is designed for saw­
ing wood and panel materials.
It enables precise and clean cuts, in particular
angled cuts can be performed simply and with
repeat accuracy. The saw automatically moves
back to the initial position after the sawing
process.
Observe the instructions in the operating man­
ual for the FSK cross cutting guide rail

11 Environment

Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
EU only: In accordance with the European Di­
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly re­
cycling.
Information on REACH: www.festool.com/reach

12 General information

Imported into the UK by
Festool UK Ltd
1 Anglo Saxon Way
Bury St Edmunds
IP30 9XH
Great Britain
12.1 Information on data privacy
The power tool contains a chip which automati­
cally stores machine and operating data. The
data saved cannot be traced back directly to an
individual.
The data can be read in a contactless manner
using special devices and shall only be used by
Festool for fault diagnosis, repair and warranty
processing and for quality improvement or en­
hancement of the power tool. The data shall not
be used in any other way without the express
consent of the customer.
12.2 Bluetooth
®
The Bluetooth ® word mark and the logos are
registered trademarks of Bluetooth SIG, Inc.;
they are used by TTS Tooltechnic Systems AG &
Co. KG, and therefore by Festool, under licence.
English
27