Changing The Saw Blade; Dust Extraction - Festool HK 85 EB Notice D'utilisation D'origine

English
saw blades must not be used to saw cement-
bonded fibreboard.
Colour Material
Yellow Wood
Red Laminate, mineral ma­
terial
Green Plaster- and cement-
bonded chipboard and
fibreboard
Blue Aluminium, plastic
7.6

Changing the saw blade

WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
WARNING
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
► Wear antistatic safety shoes when chang­
ing tools.
Removing the saw blade
► Swivel saw to 0° position before replacing
the saw blade and set maximum cutting
depth.
► Position saw on motor cover when replac­
ing .
► Turn the lever [4-3] as far as the stop.
► Open the screw [4-7] using the Allen
key [4-2].
► Hold the pendulum guard open [4-6] only
with retractor lever [4-4].
► Remove the saw blade [4-8].
Inserting the saw blade
WARNING! Check the screws and flange for
contamination and only use clean and undam­
aged parts.
► Insert the new saw blade.
WARNING! The direction of rotation of the
saw blade [4-9] and saw [4-5] must match.
24
Serious injuries may occur in the event of
non-compliance.
► Insert the outer flange [4-10] so that the pin
Symbol
engages in the recess on the inner flange.
► Release retractor lever [4-4] and allow the
pendulum guard [4-6] to swivel back to its
final position.
► Tighten the screw [4-7].
► Reposition the lever [4-3].
HPL/TRESPA ®
Risk of injury
If a clamping flange is loose, the cutting
edges of the saw blade may break off, and if
a screw is loose, the saw blade may become
detached.
► Whenever you replace a saw blade, always
7.7
Health hazard posed by dust
► Always work with an extractor.
► Comply with national regulations.
► When sawing carcinogenic materials, al­
Independent extraction
► Secure the connection piece of the dust
collection bag at the extractor connector
with a clockwise rotation.
► To empty, remove the connection piece of
the dust collection bag from the extractor
connector with an anti-clockwise rotation.
Festool mobile dust extractor
A Festool mobile dust extractor with a suction
hose diameter of 27/32 mm or 36 mm (36 mm
recommended due to the reduced risk of clog­
ging) can be connected to the extractor connec­
tor .
The adapter on a 27 diameter suction hose is
inserted into the angle adapter . The adapter on
a 36 diameter suction hose is inserted over the
angle adapter .
CAUTION! A static charge may build up if no
antistatic suction hose is used. The user may
receive an electric shock and the power tool's
electronics may be damaged.
WARNING
check that it is securely in place.

Dust extraction

WARNING
ways connect a suitable extraction mobile
in accordance with national regulations. Do
not use the chip collection bag.