Adjusting The Cutting Depth; Changing The Saw Blade; Dust Extraction - Festool TS 55 REBQ Notice D'utilisation D'origine/Liste De Pièces De Rechange

TS 55
GB
Current limiting
Current limiting prevents permissibly high cur-
rent consumption under extreme overload,
which can lead to a decrease in the motor
speed. The motor immediately restarts after
the load is removed.
Brake
The TS 55 REBQ is fitted with an electronic
brake. When the saw is switched off, the brake
stops the saw blade electronically within ap-
prox. 2 seconds.
7.2

Adjusting the cutting depth

The cutting depth can be adjusted to between
0 – 55 mm on the cutting depth stop [3-1]:
The sawing unit can now be pressed down to
the set cutting depth.
Cutting depth without guide rails
max. 55 mm
Cutting depth with guide rail FS
+FS
max. 51 mm
7.3 Adjusting the cutting angle
between 0° and 45°:
Unscrew the rotary knobs [4-1].
Swivel the sawing unit to the desired cut-
ting angle [4-2].
Tighten the rotary knobs [4-1].
Both positions (0° and 45°) are set at the
factory and can be readjusted by the after-
sales service team.
When making angled cuts, slide the
viewing window/splinterguard to the
highest position!
to undercut -1° and 47°:
Swivel the saw unit to the end position (0°/
45°) as described above.
Pull out the release button [4-3] slightly.
The saw unit engages in the -1°/47° posi-
tion.
Tighten the rotary knobs [4-1].
7.4

Changing the saw blade

CAUTION
Hot and sharp tools
Risk of injury
Wear protective gloves!
18
Before changing the saw blade, set the ma-
chine to the 0° position and select the max-
imum cutting depth..
Fold over the lever [5-2] to its end posi-
tion.
Push up the switch-on lock [5-1] and push
down the saw unit until it engages.
Loosen the screw [5-5] using the Allen key
[5-3].
Remove the saw blade [5-7].
Insert a new saw blade.
The rotational direction of the saw
blade [5-8] and machine [5-6]
must be the same!
Insert the outer flange [5-9] so that the
pin engages in the recess on the inner
flange.
Tighten the screw [5-5] firmly.
Fold back the lever [5-2].
7.5 Fitting the viewing window/
splinterguard [6]
The viewing window (transparent) [6-1]
provides a view of the saw blade and optimises

dust extraction.

With 0° cuts, the splinterguard (green) [6-
2] also improves the quality of the cutting
edge of the sawn-off workpiece on the upper
side.
Insert the splinterguard [6-2].
Screw the rotary knob [6-3] through the
long hole in the splinterguard.
Make sure that the nut [6-4] is seated se-
curely in the splinterguard.
You must bed in the splinterguard before using
it:
Set the machine to maximum cutting
depth.
Set the machine speed to 6.
7.6 Dust extraction
WARNING
Dust hazard
Dust can be hazardous to health. Always
work with a dust extractor.
Always read applicable national regula-
tions before extracting hazardous dust.