Aluminium Processing - Festool TS 55 REBQ Notice D'utilisation D'origine/Liste De Pièces De Rechange

Vibration emission level (3 directions)
Sawing wood
Sawing metal
Uncertainty
The specified emissions values (vibration,
noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise
loads during operation.
– They represent the primary applications of
the power tool.
Increase possible for other applications, with
other insertion tools or if not maintained ad-
equately. Take note of idling and downtimes
of machine!
5.4

Aluminium processing

When processing aluminium, the fol-
lowing measures must be taken for
safety reasons:
– Install an upstream residual-current circuit
breaker (FIG, PRCD).
– Connect the machine to a suitable dust ex-
tractor.
– Regularly remove dust deposits from the
motor housing.
– Use a aluminium saw blade.
– Close the viewing window/chipguard.
Wear protective goggles.
– When sawing panels, they must be lubri-
cated with petroleum but thin-walled pro-
files (up to 3 mm) can be sawed without
lubrication.
6 Operation
WARNING
Unauthorised voltage or frequency!
Risk of accident
The mains voltage and the frequency of the
power source must correspond with the
specifications on the machine's name plate.
In North America, only Festool machines
with the voltage specifications 120 V/60
Hz may be used.
2
a < 2,5 m/s
h
2
Connecting and detaching the mains power
a = 2,8 m/s
h
cable [1-11] see Fig. [2].
2
K = 1,5 m/s
Slide the switch-on lock [1-6] upwards and
press the on/off switch [1-7] (press = ON /
release = OFF).
7
Risk of injury, electric shock
7.1
The machine (TS 55 REBQ/ TS 55 REQ) fea-
tures full-wave electronics with the following
properties:
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
Constant speed
The motor speed remains constant through
electronic control to ensure a uniform cutting
speed even when under load.
Speed control
You can regulate the speed steplessly within
the speed range using the adjusting wheel [1-
10] (see Technical data). This enables you to
optimise the cutting speed to suit the surface
(see table 1).
Temperature cut-out
The machine power supply is limited and the
speed reduced if the motor exceeds a certain
temperature. The machine continues operat-
ing at reduced power to allow the ventilator to
cool the motor quickly. If the machine temper-
ature exceeds the maximum permitted value
for longer periods, the machine switches off
completely after approx. 40 seconds and can
only be switched on again once the motor has
cooled sufficiently.
Always switch the machine off before
connecting or disconnecting the mains
lead!
Pressing the switch-on lock unlocks the
plunging mechanism. The saw unit can
then be moved downwards. This causes
the saw blade to emerge from the pro-
tective cover.
Settings
WARNING
Always pull the plug out of the socket be-
fore performing any type of work on the
machine!
Electronics
TS 55
GB
17