Cold Weather Operation - DeWalt DWF83C Guide D'utilisation

4. Swing cover closed.
5. Close the door: Check that latch engages. (If it does not engage,
check that the nail heads are in the slot on the nose.)
Depth Setting (Fig. 7)
WARNING: Disconnect air line from tool and remove fasteners
from canister before making adjustments or personal injury may result.
The fastener depth control adjustment feature provides control of
the nail drive depth from flush with or just above the work surface
to shallow or deep countersink.
Rotate depth control adjustment wheel (H) to give the desired depth
of drive.
FIG. 7
Rafter Hook (Fig. 1)
The integrated rafter hook (C) can be rotated to either side of the tool
to accommodate left- or right-handed users.
NOTE: The rafter hook can not be removed.

Cold Weather Operation

WARNING: Read the section titled Important Safety Instructions
at the beginning of this manual. Always wear eye and ear protection
when operating this tool. Keep the nailer pointed away from yourself
and others. For safe operation, complete the following procedures
and checks before each use of the nailer.
When operating tools at temperatures below freezing, complete
preparation procedures outlined above and follow the directions below.
1. Make sure compressor tanks have been properly drained prior
to use. Always drain the compressor tanks at least once daily
while using the nailer. This is especially important in cold weather
because any moisture in the air in the tanks will condense in the
cold temperature.
2. Keep the tool as warm as possible prior to use.
3. Put 5 to 10 drops of D
pneumatic oil containing ethylene glycol in the end cap.
4. Lower air pressure to 80 psi or less.
5. Actuate the tool 5 or 6 times into scrap lumber to lubricate o-rings.
6. Turn pressure up to operating level (not to exceed 120 psi) and
use tool as normal.
7. Re-lubricate with D
pneumatic oil containing ethylene glycol in the end cap at least
twice a day or after 4 hours of use.
Hot Weather Operation
H
Tool should operate normally. However, keep tool out of direct
sunlight as excessive heat can damage bumpers, o-rings and other
rubber parts.
MAINTENANCE
WARNING: Disconnect air line from tool and remove fasteners
from magazine before making adjustments or personal injury
may result.
Clearing a Jammed Fastener (Fig. 8)
WARNING: Disconnect air line from tool, engage trigger lock
and remove fasteners from canister before making adjustments or
personal injury may result.
9
WALT Pneumatic Tool Oil or winter weight
e
WALT Pneumatic Tool Oil or winter weight
e