Cold Weather Operation - DeWalt DWMC150 Guide D'utilisation

1. Hold nailer with magazine (F) tilted downward and insert
appropriate collated nail sticks into magazine. Refer to Tool
Specifications to determine correct fasteners.
2. Slide nails all the way to the front of magazine.
3. Pull pusher (E) towards rear of magazine past the last nail, then
release to engage pusher to strip of nails.
FIG. 5
TO REMOVE NAILS (FIG. 1, 6, 7)
1. Depress the pusher (E) and slowly slide pusher forward past the
nails to the nosepiece.
FIG. 6
2. Remove nails by releasing the pusher spring and sliding nails
backwards.
3. Depress the pusher (E) and slide nails past magazine tab and
out the magazine.
FIG. 7
Rafter Hook (Fig. 1)
WARNING: Never use rafter hook to hang tool from body, clothing
or belt.
The integrated rafter hook (C) can be rotated to either side of the tool
to accommodate left- or right-handed users.
NOTE: The rafter hook can not be removed.

Cold Weather Operation

WARNING: Read the section titled Important Safety Instructions
at the beginning of this manual. Always wear eye and ear protection
when operating this tool. Keep the nailer pointed away from yourself
and others. For safe operation, complete the following procedures
and checks before each use of the nailer.
When operating tools at temperatures below freezing, complete
preparation procedures outlined above and follow the directions
below.
1. Make sure compressor tanks have been properly drained prior
to use. Always drain the compressor tanks at least once daily
while using the nailer. This is especially important in cold weather
8