DeWalt DWMC150 Guide D'utilisation page 12

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING: Never tamper with or disassemble contact trip (CT)
housing assembly, it can cause severe injury to the user or to
bystanders. Contact trip housing must be replaced as a complete
assembly only.
CAUTION: Pusher spring (constant force spring). Caution must
be used when working with the spring assembly. The spring is
wrapped around, but not attached to, a roller.
extended beyond its length, the end will come off the roller and the
spring will roll up with a snap, with a chance of pinching your hand.
Also the edges of the spring are very thin and could cut. Care must
also be taken to insure no permanent kinks are put in the spring as
this will reduce the springs force.
Refer to the Troubleshooting Guide at the end of this section.
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment should be performed by a D
center, a D
WALT authorized service center or other qualified service
E
personnel. Always use identical replacement parts.
Accessories
WARNING: Since accessories, other than those offered by
D
WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk of
injury, only D
WALT, recommended accessories should be used with
E
this product.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service center.
If you need assistance in locating any accessory, please contact
DEWALT Industrial Tool Co., 701 East Joppa Road, Towson, MD
21286, call 1-800-4-DEWALT (1-800-433-9258) or visit our website
www.dewalt.com.
Register Online
Thank you for your purchase. Register your product now for:
• WARRANTY SERVICE: Registering your product will help you
obtain more efficient warranty service in case there is a problem
with your product.
• CONFIRMATION OF OWNERSHIP: In case of an insurance
If the spring is
loss, such as fire, flood or theft, your registration of ownership will
serve as your proof of purchase.
• FOR YOUR SAFETY: Registering your product will allow us to
contact you in the unlikely event a safety notification is required
under the Consumer Product Safety Act.
Register online at www.dewalt.com/register.
Seven Year Limited Warranty
D
WALT will repair, without charge, any defects due to faulty materials
WALT factory service
E
E
or workmanship for seven years from the date of purchase. This
warranty does not cover part failure due to normal wear or tool
abuse. For further detail of warranty coverage and warranty repair
information, visit www.dewalt.com or call 1-800-4-D
433-9258). This warranty does not apply to accessories or damage
caused where repairs have been made or attempted by others. This
warranty gives you specific legal rights and you may have other rights
which vary in certain states or provinces.
In addition to the warranty, D
D
WALT will maintain the tool and replace worn parts caused by
E
normal use, for free, any time during the first year after purchase.
Nailer wear items, such as o-rings and driver blades, are not covered.
10
E
WALT tools are covered by our:
E
1 YEAR FREE SERVICE
WALT (1-800-

Publicité

Table des Matières
loading

Table des Matières