Changing The Sanding Drum; Dust Collection - Kunzle & Tasin Bona Belt Manuel D'utilisation

Machine Adjustment Procedures (Cont.)

Changing the sanding drum

If the sanding drum needs to be removed for cleaning or replacement, then do the following:
1.
Put the machine backward
so that it rests on the tilt
support and handle.
5.
Unscrew the nut and remove
the plate.
9.
Thread on the washer and
tighten the nut

Dust Collection

Once sanding is complete, the dust bag must be emptied and the
contents stored outdoors due to explosion risk and fire hazard.
16 16
2.
Pull the tool out directly with
a tug the sanding belt will
tighten automatically.
6.
Screw on the removal tool to
the bottom of the axle. Then
use a plastic club or hammer
directly on the tool, loosen
the tool. The drum will now
loosen from the conical axle
and can be pulled out for
cleaning or replacement.
10.
Remove the lock pin from the
sander belt plate and lift up
the belt protector.
3.
Lock the sanding drum by
pushing the steel pin into the
hole in the pulley and into the
corresponding hole in the
machine frame.
7.
Thoroughly clean the drum
axle and the drum cone on
the drum axle before putting
the drum back on again.
For minimal dust discharge Bona's original
dust bags shall always be used. The dust bag
must be emptied when it is filled to max 1/3.
Bona Belt Manual
4.
Remove the sanding belt.
8.
Turn the drum so that the
wedge shaped groove
passes over the groove on
the axle and push on the
drum.