Routine Maintenance - Kunzle & Tasin Bona Belt Manuel D'utilisation

Routine Maintenance

Before performing any service and maintenance the
power cable must be removed from the wall socket.
The motor is equipped with no volt release and overload
protection If the protection has triggered, the motor can start
normally after several minutes.
Always use original cableage, 1-phase 3x2.5 mm²
(ASO904014).
1.
Loosening the eccentric
tightener, lift off the motor
and loosen the M16 screw
nut on the eccentric tightener.
2.
Then turn the entire eccentric
tightener clockwise ½ turn.
3.
Replace the motor and
tighten the eccentric tightener
and check the belt tension.
(Repeat the procedure until
the correct belt tension is
achieved).
EN
Bona Belt Manual
17 17