Machine Warnings; Prohibited Use; The Machines Field Of Application; Usage Technique - Kunzle & Tasin Bona Belt Manuel D'utilisation

Machine Warnings

Prohibited use

Children should be
supervised to ensure that
they do not play with the
appliance. This machine
is not intended for use
by persons (including
children) with reduced
physical, sensory or mental
capabilities, or lack of
experience and knowledge
unless they have received
instructions regarding the
use and are supervised by a
person responsible for their
safety.

The Machines Field of Application

The machine is intended for sanding wooden floors, parquet
flooring and cork floors. Either when the floor is newly laid and
untreated or when the floor is used and treated with finishes
or oil. The machine has been developed in accordance with

Usage technique

1) Begin sanding by lifting the control handle up at the same
time as the control lever is moved forward/downward.
2) Then roll the machine forward at the same time as the
control handle is lowered to the lowest position, then lower
the sanding drum down to the floor and the sanding has
begun. Sanding can be carried out both when the machine
is moved forward and backward.
3) Lift the control handle slightly each time the sanding
direction is changed, then immediately lower the control
handle again, as soon as the new sanding direction has
begun.
12 12
This equipment is not
suitable for collecting
hazardous dust.
Using the machine to move objects or moving on an incline may
cause injury or damage. The machine must only be used to sand
dry floors which are level or have a maximum incline of 2%. DO
NOT use the machine to sand furniture. Work surfaces may be
seriously damaged if the machine is left turning on one point while
the tool is in contact with the surface. To avoid damaging the
surface approach the cutting line carefully. DO NOT stop when
lowering and raising the equipment, keep moving at constant
speed.
the latest findings with respect to ergonomics, safety and
efficiency. The machine is thoroughly inspected and tested
before it leaves the factory.
4) Finish the sanding while the machine is in motion by lifting
up the control handle, thus lifting the sanding drum from the
floor.
5) Then move the control lever up/backward to the start
position.
6) Stop the motor by pressing the stop button.
7) Keep the power cable away from the machine's sanding
area.
The sanding technique must be adapted to suit the floor
type, pattern and the floor's condition.
Bona Belt Manual