In The Submersible Motor-Driven Pumps - Wilo Drain-Control 1 Notice De Montage Et De Mise En Service

ENGLISH
Once rectified, the errors must be acknowledged in menu 4.01:
Tastenfolge
1f 2f
When the "MSA" error is triggered the error must also be acknow-
ledged / reset in the protective circuit of the protective motor
switch ("MSS") and thermal circuit breaker ("TSA").

8.2 In the submersible motor-driven pumps:

installation and operating instructions.
If the fault cannot be remedied, please contact your local plum-
bing and heating specialist or Wilo-customer service.
18
3f 4f 5
see pump
Beschreibung der Quittierschritte
Preselect menu 4.01
1 f „SSM" is reset, the red LED is continuously lit.
The corresponding error-code is in >....<
2 f >....< becomes I....I, flashing
3 f Repeat process until error code 0 appears and the red LED goes
out.
4 f Confirm acknowledgement flashing I....I
becomes >....< (Display: E >...0< -------)
5 f Error acknowledgement ends the standard display appears..
Technical modifications reserved!