Creation And Storage Of Manual Time Programmes - Dreve Drufomat scan Mode D'emploi

9.2 Creation and storage of manual time programmes

Up to three individual time programmes
may be created and stored for thermo-
forming foils that are not equipped with
a corresponding barcode.
Turn on the unit – the initial display
will be visible. When pushing the
menu key (j) one time the display will
show – – – – – at position b.
As described in point 9.1, push menu
key (j) and select the desired heating
time by the menu keys +/- (e/i). Follow-
ing push menu key (j) again and enter
cooling time.
For single use confirm the two entered
values by pushing OK (f). Then go on
as described in point 8.2.
If the created time programme is to
be stored for repeated use, 3 memory
capacities (F1-F3) are available.
Do not confirm the created time pro-
gramme by pushing OK, but press menu
key (j) again. The display will show F1
in position b, the entered times will be
taken over. The memory capacities F2
and F3 can be selected by pushing the
menu key (j) 2 resp. 3 times. Store the
times in the desired memory capacity
by pushing the OK key (f). Then go on
as described in point 8.2.
41 41