The Battery / Changing The Battery - IBP TD 4222 Mode D'emploi

changing the battery
The device will warn you that the battery is getting low using two different display symbols.
1. When you switch the device on, the battery symbol
showing operational readiness. In this case, there is still enough energy for around 50 tests available. Test
results will be precise, but you should still replace the battery nevertheless.
2. The display is now showing the battery symbol and "E-b" (Fig. 31). In
this case, there is no longer enough energy for a test available. Replace
the old battery with a new 3V CR2032 battery.
3. Switch the device off, and open the battery compartment on the rear
of the device by pressing the locking tab and lifting the battery compart-
ment cover upwards.
4. Press the setting button in the battery compartment for three seconds.
5. Remove the old battery, and replace it with a new 3V CR2032 lithium battery. Insert the new battery so that
the positive terminal (+) is facing upwards, and then close the battery compartment cover.
Note: Replacing the battery does not affect the memory contents. Sometimes you may have to re-set the time
and date. Dispose of empty batteries at a recycling point. If you are no longer using the device,
remove the battery from the battery compartment.
Battery safety-
information:
- Keep away from children!
- Not rechargeable!
the battery 13
appears in the display. All other display symbols are
(Fig. 31)
- Do not short-circuit!
- Do not incinerate!
27