The Batteries / Changing The Batteries - IBP TD 3213 Mode D'emploi

7 the batteries
changing the batteries
The device will warn you that the batteries are getting low using two different display symbols.
1. When you switch the device on, the battery symbol
are showing operational readiness. In this case, there is still enough energy for around 30 tests available.
Test results will be precise, but you should still replace the batteries nevertheless.
2. The display is now showing the battery symbol flashing (Fig. 4). In this
case, there is no longer enough energy for a test available. Replace the
old batteries with two new 2 x 1.5 V alkaline batteries size AAA.
3. Switch the device off, and open the battery compartment on the rear
of the device by pressing the locking tab and lifting the battery com-
partment cover upwards.
4. Remove the old batteries, and replace them with two new 2 x 1.5 V alkaline batteries size AAA. Insert the
new batteries so that the terminals match the diagram on the battery compartment, and then close the
battery compartment cover.
Note: Replacing the battery does not affect the memory contents. Sometimes you may have to re-set the time
and date. Dispose of empty batteries at a recycling point. If you are no longer using the device,
remove the battery from the battery compartment.
Battery safety-
information:
10
- Keep away from children!
- Not rechargeable!
appears in the display. All other display symbols
(Fig. 4)
- Do not short-circuit!
- Do not incinerate!