How To Call Up Individual Values / How To Quit The Memory Section - IBP TD 4222 Mode D'emploi

how to call up individual measured values
• If the device is switched off, and you press the Menu button 8
times, the last measured test results will be shown in the display with
date and time (after the 90-day average value) (Fig. 24). If you press
the Menu button again, the test result prior to this one will be
called up. By pressing the Menu button again and again, you will
call up the previous measure result (up to 450 saved measured
values) each time. If the measured value memory is full, the oldest
measured value will be deleted as soon as a new value is saved.
Note: If you are using the device for the first time, the display will show
"mem —" to show you that no test results have been saved yet.
how to quit the memory section
• Press the Menu button and hold it down for it least 3 seconds. The
display shows "OFF" and the device will switch itself off.
Note: To completely delete all memory contents, please read the
chapter entitled "device settings" on Page 26.
the measured value memory 11
( Fig. 24)
23