IBP TD 4222 Mode D'emploi page 58

9 the blood sugar test
sequently. Pull the test strip out to stop the test process. Start again
from the beginning by feeding in a new test strip and applying the
necessary blood drop. If you cannot manage to fill the test strip with
enough blood, please contact our service department.
Note: If you do not apply blood to the test strip within three minutes,
the device switches itself off automatically. Remove the strip,
and then feed it into the device again to start the test procedure
once more.
3. After the device has finished the countdown, the measured results
are shown in the display. The blood sugar test measured values
are automatically stored in the memory. To turn the device off,
pull the test strip out.
Warning: Dispose of used to test trips and used lancets very
carefully in order to prevent injury or infection to other
persons.
The measured results produced by your "ibp TD 4222" blood sugar
measuring device are precise whole blood-calibrated test results
(Fig. 19), which can be directly compared with laboratory results.
20
( Fig. 18)
Example:
correct blood
application
Example:
insufficient
blood application
( Fig. 19)
Example: whole blood-calibrated result