General Safety Instructions - EINHELL EURO 2200-1 Mode D'emploi

Anleitung Euro 2200-1 Einhell
General safety 8. Wear goggles
instructions
Important! The following basic 9. Never use the cable for any
safety precautions have to be
taken when using this
compressor in order to guard
against the risk of electric
shock, injury and fire. Read and
note these instructions before
you use the compressor.
10. Do not overreach
1. Keep your work area tidy
- There is a higher risk of
accident in an untidy work
area.
11. Look after your compressor
2. Make allowance for
environmental conditions
- Never leave the compressor
in the rain. Never use the
compressor in damp or wet
conditions. Provide good
lighting. Never use the
compressor near combustible
liquids or gases.
3. Protect yourself from
12. Pull out the power plug
electric shocks
- Avoid physical contact with
earthed parts, e.g. pipes,
radiators, cookers,
refrigerators.
13. Do not leave any tools on
4. Keep children away!
- Do not allow other persons
to touch the compressor or its
cable. Keep them out of your
work area.
14. Avoid accidental starts
5. Keep your compressor in a
safe place
- When the compressor is not
being used it should be kept
in a dry, locked room out of 15. Extension cables for
the reach of the children.
6. Do not overload your
compressor
- It is better and safer to work
within the quoted power
16. Concentrate at all times
range.
7. Wear suitable work clothes
- Do not wear loose garments
or jewellery. There is a risk of
17. Examine your compressor
them catching on moving
parts. Rubber gloves and
non-slip shoes are
recommended when working
outdoors. Put on a hair net if
you have long hair.
18.07.2003 11:39 Uhr
working properly and as
- Wear a breathing mask intended. Check moving parts
when working in dusty
to make sure that they are in
conditions.
good working order and are
not jammed or damaged. All
purpose other than that
parts have to be properly
intended
fitted in order to be sure of
Never tow the compressor by
meeting all the machine's
its cable and never pull the
requirements.
power plug out of the socket
Damaged safety devices and
by the cable. Protect the
parts have to be repaired or
cable from heat, oil and sharp
replaced by a customer
edges.
service workshop unless
otherwise stated in this
- Avoid abnormal postures.
manual. Damaged switches
Stand squarely and keep your
have to be replaced by a
balance at all times.
customer service workshop.
Do not use any tools with a
- Keep your compressor clean
switch that cannot be turned
so that it works well and
on and off.
reliably. Follow the
maintenance instructions.
18. Important!
Check the power plug and
- For your own safety, use
cable regularly and have
only such accessories and
them replaced by a specialist
auxiliary equipment as are
if you discover any damage.
listed in this manual or which
Check any extension cables
are recommended and
regularly and replace if
specified by the manu-
damaged.
facturer. There is a high risk
of suffering a serious accident
- Whenever the compressor is
if you use tools or acces-
not being used and before
sories which are not listed in
carrying out any maintenance
this manual or in the
work.
catalogue of recommended
tools and accessories.
the compressor
19. Have an electrician carry
- Before you switch on the
out repairs
compressor, make sure that
- Repairs are to be carried out
all wrenches and setting tools
only by a qualified electrician.
have been removed.
If not, the user may suffer
- Make sure that the switch is serious accidents.
turned to OFF before you 20. Connect a dust extraction
connect the compressor to
system
the power supply.
- If there are facilities for
connecting a dust extraction
outdoor use
system, check that the
- Use extension cables
system is indeed connected
outdoors only if they are
and being used.
approved and marked
21. Noise
accordingly.
- The compressor's noise is
measured in accordance with
- Watch your work. Be
IEC 59 CO 11, IEC 704, DIN
sensible. Do not use the
45635 Part 21, and NFS 31-
compressor if your mind is not
031 (84/537/EEC). The
on your work.
machine noise may exceed
85 dB(A) at the workplace. In
for signs of damage
this case, noise protection
- Before you use the
measures need to be
compressor again, carefully
introduced for the user.
check its safety devices or
any slightly damaged parts to Keep these safety instructions
make sure that they are in a safe place.
Seite 9
GB
9