Installing The Docking Station - Viking MI 422 Manuel D'utilisation

Remove the cover as described in the
"Installing the docking station" section.
( 9.5)
Then press the OK button on the
display.
0478 131 9934 A - EN
Insert the perimeter wire (1) into the cable
guides in the floor plate and guide it
through the socket (2).
Cut the ends of the perimeter wire (1) to a
free length of approx. 10 cm.
Precisely observe the free length
and do not roll up protruding wire
ends. Excessively long free ends
can interfere with correct operation
of the robotic mower.
Fasten the press-fit connectors (1) onto
the cable ends using suitable pliers –
ensure correct engagement.
The press-fit connectors can only
be fitted once on the perimeter
wire. They must not be reused
following removal. Additional press-
fit connectors are available from a
VIKING specialist dealer. ( 17.)
101