Viking MI 422 Manuel D'utilisation page 104

Position the perimeter wire (1)
within the two markings (2).
Attach the connector (3) to both
pins (4) as shown. Ensure correct
connection of the left and right perimeter
wire ends – do not interchange the wire
ends.
Close the cover of the cable duct (5).
● After completing this installation
work, press the OK button on the
display.
Fit the cover as described in the "Installing
the docking station" section. (
Then press the OK button on the
display.
102
Connect the power supply unit plug
to the mains, then press the OK
button.
When the perimeter wire is correctly
installed and the docking station is
connected to the mains power supply, the
red LED (1) illuminates.
Observe the "Docking station"
section, particularly if the LED does
not illuminate as described.
( 12.1)
9.5)
Lift the robotic mower slightly by the
carrying handle (1) to relieve the weight on
the drive wheels. Push the machine,
resting on its front wheels, into the docking
station.
The LED on the docking station flashes
slowly after docking. ( 12.1)
Then press the OK button on the
display.
0478 131 9934 A - EN