Setting Up The Clamping Position En; Setting Up The Compressed-Air Motor En - Abicor Binzel BRS-CC Mode D'emploi

BRS-CC
5.6 Setting up the clamping position
Gas nozzle
1
Setting up the clamping position
Fig. 8
 See also Fig. 5 Putting into operation on page EN-10
1 Move the torch with the gas nozzle (1) vertically to the tool axis (milling cutter axis) over the
BRS-CC (3) (P1).
2 Approach the clamping position (P2). Make sure that the cylindrical part of the gas nozzle (1) lies evenly
against the prism (2).
5.7 Setting up the compressed-air motor
1 Clamping device
Gas nozzle
2
Setting up the compressed-air motor
Fig. 9
 See also Fig. 5 Putting into operation on page EN-10
1 Loosen the compressed-air motor from the guide block (4) by removing the screws (3).
2 Pull back the compressed-air motor (5) in its fastener.
3 Place the required distance sleeve (7) on the milling cutter (6).
4 Move the torch with the gas nozzle (2) to the clamping position (P2).
5 Keep the guide block (4) in the lower position (lift down).
6 Place the compressed-air motor (5) against the gas nozzle (2) with the distance sleeve placed
on top (7).
1
Prism
2
1
7
6
5
3 Screws
Guide block
4
2
3
Maintenance unit BRS-CC
3
2
3
4
5 Compressed-air motor
Milling cutter
6
5 Putting into operation
7 Distance sleeve
EN - 12