Dav Wire Cutting Device En; Fastening The Prism En; Mounting The Milling Cutter En - Abicor Binzel BRS-CC Mode D'emploi

Masquer les pouces Voir aussi pour BRS-CC:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5 Putting into operation
NOTE
Inflowing compressed air sucks in the anti-spatter fluid and mixes it with the compressed air flow (Venturi
principle). Recommended waiting time: approx. 1 sec.
5.3 DAV wire cutting device
 See Fig. 5 Putting into operation on page EN-10
1 With the free wire end, move the torch into the cutting area of the wire cutter so that the wire has contact
with the fixed jaws and the gas nozzle is positioned directly over the cutter (5).
2 Program the positions and commands as described in the flow chart.
5.4 Fastening the prism
Clamping device
1
Fastening the prism
Fig. 6
1 Insert the prism (2) into the clamping device (1) from above.
2 Screw in the cylinder head screw (3).
5.5 Mounting the milling cutter
Clamping device
1
Fig. 7
Mounting the milling cutter
NOTE
• Use only tools with a suitable width across flats when changing the milling cutter.
1 Put the milling cutter (2) in the clamping device (1).
2 Secure the milling cutter (2) by means of tools (3).
EN - 11
1
Prism
2
1
Milling cutter
2
Milling cutter seat - width 27, milling cutter - width 17.
2
3
Cylinder head screw
3
2
3
Tool
3
BRS-CC

Publicité

Table des Matières
loading

Table des Matières